Rear Shoe brakes

1992 CHEVROLET CORSICA
125 MILES • 6 CYL • 2WD • AUTOMATIC
Avatar
MOSSWIGGLE
  • MEMBER
  • 1 POST
I just put in new rear shoe brakes on my 92 Chevy Corsica. Everything seems to be in place properly but now the drum won't fit back on.
May 24, 2011 at 12:07 AM
Advertisement
Avatar
CARADIODOC
  • ASE Certified Mechanic
  • 34,321 POSTS
  • ASE Certified Mechanic
Check that the frames of both shoes are contacting the large anchor pin on top. Next, use your thumb to push the parking brake strut rod against the anit-rattle spring. It should move at least 1/8". If either of those are not happening, the parking brake cable is not fully released.

Be sure you have the correct shoes in the right places. Short lining goes toward the front of the car, longer lining toward the rear. If two long linings are on the same side, the drum won't fit over them.
May 24, 2011 at 8:21 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.