1992 cadillac deville

1992 CADILLAC DEVILLE
135,000 MILES
Avatar
SEAN03
  • MEMBER
  • 523 POSTS
How hard would it be to flare and bend a metal brake line. The one that I need is a small line that connects into the back of my 1992 cadillac deville wheel cylinder. And the other end connects into the rear brake hose.
Jun 8, 2012 at 8:22 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
SATURNTECH9
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 30,869 POSTS
Not that hard you may be able to rent a flaring tool from auto zone.You will need a tubing cutter and a tubing bender.
Jun 8, 2012 at 9:43 PM
Advertisement
Avatar
SEAN03
  • MEMBER
  • 523 POSTS
I have a tubing cutter and I have a flaring tool for hvac. I just need to buy or rent a bender.
Jun 8, 2012 at 9:55 PM
Avatar
SATURNTECH9
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 30,869 POSTS
Benders are pretty cheap so it wouldnt be too bad if you had to buy one.
Jun 8, 2012 at 10:06 PM
Avatar
SEAN03
  • MEMBER
  • 523 POSTS
ok Thanks.
Jun 8, 2012 at 10:08 PM
Avatar
SATURNTECH9
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 30,869 POSTS
Anytime.
Jun 8, 2012 at 10:10 PM