How to adjust clutch pedal

110,000 MILES
Avatar
BERTUS DE JAGER
  • MEMBER
  • 1 POST
I have replaced the clutchplate , pressure plate and release bearing on my toyota corolla 1.3 and now the clutch only engage very low down , in fact on the floorboard. How can i adjust the clutch to engage higher.
Many thanks
bertus
Jan 2, 2012 at 12:23 AM
Avatar
KHLOW2008
  • ✓Experienced Mechanic
  • 41,812 POSTS
If bleeding does not work, try the following.

CLUTCH PEDAL HEIGHT

Pedal height is measured from highest point of pedal pad to area of floor contacted when pedal is fully depressed. Loosen the pedal stop bolt at the top of the pedal assembly to adjust pedal height from floor to the following, 5.71-6.10 ins (145.0-154.9 mm). See Fig. 1 .

CLUTCH PEDAL FREE PLAY

1. Push in on clutch pedal until beginning of clutch resistance is felt. Clutch pedal free play should be .20-.59" (5.0-15.0 mm). See
Fig. 2 .

2. To adjust free play, loosen the lock nut on master cylinder push rod and turn push rod to obtain the correct pedal free play. See
Fig. 1. Tighten lock nut, and recheck pedal height.

Jan 2, 2012 at 5:06 AM
Avatar
FIXITMR
  • ✓Experienced Mechanic
  • 9,989 POSTS
another thing to consider is engage point will change with wear and it will go from close to floor upwards as it does.
Jan 2, 2012 at 11:08 AM
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle