91 pontiac grand am

1991 PONTIAC GRAND AM
4 CYL
Avatar
KROUNDY
  • MEMBER
  • 3 POSTS
I have a Pontiac grand am 91. I was driving down the road and it just cut off. All the fuses are good and the fuel pump is good and the fuel filter, It has spark to the plugs. It cranks over but will not start up. What else can I check?
May 13, 2011 at 7:31 PM
Advertisement
Avatar
JDL
  • ASE Certified Mechanic
  • 16,098 POSTS
  • ASE Certified Mechanic
Use a noid lite, check for injector pulse, engine cranking. Any applicable mil codes? You can check those, yourself.

Use a gage and check fuel pressure.
May 13, 2011 at 7:37 PM
Avatar
KROUNDY
  • MEMBER
  • 3 POSTS
it does not have fuel injection and the fuel pressure is good.
May 13, 2011 at 7:49 PM
Avatar
JDL
  • ASE Certified Mechanic
  • 16,098 POSTS
  • ASE Certified Mechanic
If the fuel setup isn't factory, I don't know what to tell you? What is the fuel pressure spec?
May 13, 2011 at 8:02 PM
Avatar
KROUNDY
  • MEMBER
  • 3 POSTS
It's factory setup nothing new on it. No fuel injection it has a carburetor. The pressure was around like 41psi or so.
May 13, 2011 at 8:14 PM
Avatar
JDL
  • ASE Certified Mechanic
  • 16,098 POSTS
  • ASE Certified Mechanic
You should have fuel injection. My info shows this, below, for 2.3L engine.

How about checking for trouble codes? Use a jumper wire between A & B terminals of data link connector. Turn key just till dash lites come on, no further, mil starts flashing, you count the flashes to get the codes. Your looking for two digit codes.
May 24, 2011 at 6:01 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.