ac/heater quit

6 CYL • 2WD • AUTOMATIC
Avatar
SAH1960
  • MEMBER
  • 1 POST
need to know how to get to heater fan motor on a 1991 grand plymouth voyager to replace myself.i know it inside dash.
Dec 8, 2010 at 7:49 AM
Advertisement
Avatar
RASMATAZ
  • ✓Experienced Mechanic
  • 75,988 POSTS
WARNING: If equipped with air conditioning,the refrigeration system must be completely discharged before proceeding with this operation.

Set parking brake.
Disconnect negative battery cable.
Discharge refrigerant system.
Expansion Valve

Disconnect all engine compartment lines and vacuum hoses.
Drain engine coolant. Plug coolant lines.
Remove the steering column cover.
Remove the left under panel silencer.
Remove the right under panel silencer.
Instrument Panel Assembly
Remove the center bezel (clips to instrument panel).
Remove the accessory switch carrier.
Remove Heat-A/C controls.
Remove standard storage module.
Remove the right lower instrument panel.
Remove the right 40-way wiring bracket.
Remove the lower right reinforcement, body computer bracket, and mid-to-lower reinforcement as one assembly.
Disconnect all necessary instrument panel wiring and temporarily route wiring out of the way.
Disconnect the' A/C unit hanger strap from the unit and temporarily re-position.
Resistor Block And Drain Tube

Remove the rubber condensate drain tube (in engine compartment).
Remove the four nuts (in the engine compartment) securing the unit to the dash panel.
Pull the entire unit rearward until the studs on the unit clear the dash panel. Drop the unit down and pull it rearward to remove it from vehicle.



Dec 8, 2010 at 7:55 AM
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle