1991 Plymouth Acclaim Car Struggles Move Reverse Tran Fluid Fine

1991 PLYMOUTH ACCLAIM
140 MILES • 4 CYL • 2WD • AUTOMATIC
Avatar
FIXITMR
  • ASE Certified Mechanic
  • ASE Certified Mechanic
  • 9,990 POSTS
car struggles to move in reverse tran fluid fine
Mar 8, 2013 at 9:57 PM
Advertisement
Avatar
HMAC300
  • ASE Certified Mechanic
  • 48,601 POSTS
  • ASE Certified Mechanic
have a trasn guy look atit it may have clutch/seal problems.
Mar 8, 2013 at 10:48 PM
Avatar
FIXITMR
  • ASE Certified Mechanic
  • 9,990 POSTS
  • ASE Certified Mechanic
it does move backwards slow. what it does is resist moving. like the car is stuck or something. forward is fine. happened suddenly i beleive. no problems before this with drivetrain.
Mar 9, 2013 at 12:29 AM
Avatar
HMAC300
  • ASE Certified Mechanic
  • 48,601 POSTS
  • ASE Certified Mechanic
sounds like either a pump pressure problem or a troque converter problem or you have two clutches applying that arenot supposedto be it cold also be a bad roller clutch in it. have a trans guy diagnose it
Mar 9, 2013 at 12:43 AM
Avatar
FIXITMR
  • ASE Certified Mechanic
  • 9,990 POSTS
  • ASE Certified Mechanic
the car drives fine shifts fine it's just the reverse that is not right. i actually have not looked at car yet myself just got description from relative. i was thinkin maybe it could be somethin other than trans like a brake issue or wheel issue?
Mar 9, 2013 at 4:25 PM
Avatar
HMAC300
  • ASE Certified Mechanic
  • 48,601 POSTS
  • ASE Certified Mechanic
if it were a brake issue it woldn'tmove forward either or make bang due to parking brake hanging up. REverse requires the most pressure inside the transmission to operate that is why i said have a trans guy look at it. You could have lost a clutch like a front or dierct clutch or an overdirve thrust bearing has failed. I'd bet the fluid is crappy looking as well
Mar 9, 2013 at 4:34 PM
Avatar
FIXITMR
  • ASE Certified Mechanic
  • 9,990 POSTS
  • ASE Certified Mechanic
i know the back brakes were really rusty cause car sat for yrs. thinik maybe a shoe came loose and wedged but like you say i would expect a clunk noise. i think if when i get to it if i cant see anything obvious with inspection of car i will put front wheels off ground and see what happens.
Mar 10, 2013 at 4:16 AM
Avatar
FIXITMR
  • ASE Certified Mechanic
  • 9,990 POSTS
  • ASE Certified Mechanic
so a mechanic looked at it and said back brake on 1 wheel is jammed only turns forward easily. something wrong inside drum. so i think i guessed right on piece of shoe got loose and stuck between another shoe and drum. or it's just too tight?
Mar 15, 2013 at 8:06 PM
Avatar
HMAC300
  • ASE Certified Mechanic
  • 48,601 POSTS
  • ASE Certified Mechanic
pull it off and look at it whichshold have been done in the first place. make sure the shoes are on correctly, smaller shoe in front
Mar 20, 2013 at 2:25 PM
Avatar
FIXITMR
  • ASE Certified Mechanic
  • 9,990 POSTS
  • ASE Certified Mechanic
it WAS the drivers rear BRAKE that was causing problem. drum was fine. shoes were bad worn and drum had lots of crud in it. new shoes/hardware and it's fine now.
Mar 28, 2013 at 5:23 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.