1991 Jeep Cherokee frame, motor support

1991 JEEP CHEROKEE
200,000 MILES
Avatar
1992DAKOTA
  • MEMBER
  • 9 POSTS
I have a 1991 Cherokee that I keep blowing motor mounts in. I have considered making solid mounts instead of rubber ones. Any reasons why I should or shouldn't? I have also considered making stronger braces for tranny. I want to reinforce for rough driving across country.
Jun 11, 2013 at 2:54 PM
Advertisement
Avatar
JACOBANDNICKOLAS
  • ✓ASE Certified Mechanic
  • 110,194 POSTS
  • ASE Certified Mechanic
I wouldn't recommend making a solid mount. It will vibrate bad when you drive.
Jun 11, 2013 at 8:17 PM
Avatar
1992DAKOTA
  • MEMBER
  • 9 POSTS
OK, thanks for the tip. Do you have any ideas??
Jun 12, 2013 at 2:00 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.