On her 1991 ford festiva. Transmission is free from the engine but caught on a bind in the splines. How do I fix this?
Feb 1, 2012 at 11:17 AM
I am helping a friend replace her clutch
1991 FORD FESTIVA
CSDADDY1107
- MEMBER
- 1 POST
- FOLLOW
Advertisement
Do you mean the transmission cannot free fully from engine?
Did you support the engine well?
Did you support the engine well?
Feb 1, 2012 at 12:15 PM
Hey I did this 2 weeks ago on my daughters car. I know this is a dumb question but did you pull out the half shafts?
I looked at it after I was ready to pull the tranny I looked at it and decided one more motor mount, exhaust, and a few hoses and plugs I'll just pull the whole engine tranny out together. It was easy to replace hanging of the hoist. It made it real easy to change the timing belt at this point also.
I looked at it after I was ready to pull the tranny I looked at it and decided one more motor mount, exhaust, and a few hoses and plugs I'll just pull the whole engine tranny out together. It was easy to replace hanging of the hoist. It made it real easy to change the timing belt at this point also.
Feb 3, 2012 at 10:56 PM
what do you mean by bind?
Feb 4, 2012 at 11:40 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.