where is the engine controle computer located on car?
Dec 15, 2012 at 8:33 PM
1991 FORD FESTIVA
ANONYMOUS
- MEMBER
- 1 POST
- FOLLOW
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
REMOVAL
Disconnect the negative battery cable.
Reach under the instrument panel and remove the heater duct.
Disconnect the Electronic Control Assembly (ECA) connectors.
Electronic Control Assembly (ECA)
Remove the ECA mounting bolts.
Electronic Control Assembly (ECA)
Remove the ECA.
INSTALLATION
NOTE: When installing the ECA, be sure to insert the mounting clip into the bulkhead recess.
Electronic Control Assembly (ECA)
Place the ECA into its mounting position.
Install the ECA mounting bolts and nut.
Connect the ECA electrical connectors.
Install the heater duct.
Connect the negative battery cable.
Disconnect the negative battery cable.
Reach under the instrument panel and remove the heater duct.
Disconnect the Electronic Control Assembly (ECA) connectors.
Electronic Control Assembly (ECA)
Remove the ECA mounting bolts.
Electronic Control Assembly (ECA)
Remove the ECA.
INSTALLATION
NOTE: When installing the ECA, be sure to insert the mounting clip into the bulkhead recess.
Electronic Control Assembly (ECA)
Place the ECA into its mounting position.
Install the ECA mounting bolts and nut.
Connect the ECA electrical connectors.
Install the heater duct.
Connect the negative battery cable.
Dec 15, 2012 at 8:39 PM
Advertisement