power window

181,000 MILES • 6 CYL • 4WD • AUTOMATIC
Avatar
SWEDE
  • MEMBER
  • 1 POST
how do I remove/repair window regulator on 91 Ford Explorer
Dec 2, 2010 at 7:56 AM
Advertisement
Avatar
BMRFIXIT
  • ✓Experienced Mechanic
  • 19,053 POSTS
Remove the door trim panel and watershield.
If vehicle is equipped with power windows, disconnect the wire from the regulator.
Remove the door glass as outlined in this section.
Remove the window guide, if equipped, (nuts and washers) and remove guide from door belt opening.
Remove three 1/4-inch rivets attaching motor bracket (electric) to inner panel and two 1/4-inch rivets attaching lower bracket of regulator to inner panel. Use drift punch to knock out center pins for each rivet. Using a 1/4-inch diameter drill, drill out the remainder of the rivet. Use care not to enlarge sheet metal holes in the door inner panel.
Remove two upper regulator attaching nuts.
Remove regulator from the door.
Dec 2, 2010 at 9:00 AM
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle