Power window

Remove the door trim panel and watershield.
If vehicle is equipped with power windows, disconnect the wire from the regulator.
Remove the door glass as outlined in this section.
Remove the window guide, if equipped, (nuts and washers) and remove guide from door belt opening.
Remove three 1/4-inch rivets attaching motor bracket (electric) to inner panel and two 1/4-inch rivets attaching lower bracket of regulator to inner panel. Use drift punch to knock out center pins for each rivet. Using a 1/4-inch diameter drill, drill out the remainder of the rivet. Use care not to enlarge sheet metal holes in the door inner panel.
Remove two upper regulator attaching nuts.
Remove regulator from the door.