Why is one side of the radio have static?

1991 CHEVROLET VAN
103,000 MILES
Avatar
KYLEHERTZLER
  • MEMBER
  • 6 POSTS
when i play the radio or tape it will get fuzzy on only the passenger side. Dash, door and rear speakers. it still has the stock radio in it
Dec 16, 2011 at 8:40 PM
Advertisement
Avatar
JACOBANDNICKOLAS
  • ASE Certified Mechanic
  • 110,194 POSTS
  • ASE Certified Mechanic
I would start by making sure the wiring harness to the rear of the radio is tight. It may have come loose over the years.
Dec 16, 2011 at 8:46 PM
Avatar
KYLEHERTZLER
  • MEMBER
  • 6 POSTS
i have the radio out and the wires are in tight and it is still fuzzy. i tried wiggling them but that doesn't change anything.
Dec 16, 2011 at 8:52 PM
Avatar
JACOBANDNICKOLAS
  • ASE Certified Mechanic
  • 110,194 POSTS
  • ASE Certified Mechanic
The only other thing that I can think of is the amp in the radio is starting to go bad.
Dec 16, 2011 at 8:55 PM
Avatar
KYLEHERTZLER
  • MEMBER
  • 6 POSTS
ok i am getting a radio out of a 96 buick regal according to some other sites online that should fit. in case it doesn't what do you suggest? go to a scrap yard or get a new one?
Dec 16, 2011 at 8:58 PM
Avatar
JACOBANDNICKOLAS
  • ASE Certified Mechanic
  • 110,194 POSTS
  • ASE Certified Mechanic
It should fit. If it doesn't, go to a salvage yard and get one. If you get an aftermarket one, then you need to modify the wiring.
Dec 16, 2011 at 9:00 PM
Avatar
KYLEHERTZLER
  • MEMBER
  • 6 POSTS
alright thanks for all your help i will see what happens.
Dec 16, 2011 at 9:03 PM
Avatar
JACOBANDNICKOLAS
  • ASE Certified Mechanic
  • 110,194 POSTS
  • ASE Certified Mechanic
Let me know if you have other questions.
Dec 16, 2011 at 9:03 PM
Avatar
FIXITMR
  • ASE Certified Mechanic
  • 9,990 POSTS
  • ASE Certified Mechanic
did you test the speaker?
Dec 16, 2011 at 9:13 PM
Avatar
KYLEHERTZLER
  • MEMBER
  • 6 POSTS
the way that i tested it was hard to tell but it is all the speakers on the passenger side. all the ones on the drivers side are ok. i have a headphone jack with 2 bare wires that i put into my iPod and then touched to the hot points and some sound came through. is there a better way to test it?
Dec 16, 2011 at 9:20 PM
Avatar
FIXITMR
  • ASE Certified Mechanic
  • 9,990 POSTS
  • ASE Certified Mechanic
well ideally if you could rig good side to play out other side that would be the best test.
Dec 17, 2011 at 12:47 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.