1991 Chevrolet Storm Clutch cable

1991 CHEVROLET STORM
136,000 MILES • 0.5L • 4 CYL • 2WD • MANUAL
Avatar
SCHAZZAR
  • MEMBER
  • 5 POSTS
My stick shift grinds and wont go into gear
Jul 12, 2014 at 6:11 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
HMAC300
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 48,601 POSTS
check for a broken cable if the release arm moves then your clutch may be shot
Jul 13, 2014 at 8:45 AM
Advertisement
Avatar
SCHAZZAR
  • MEMBER
  • 5 POSTS
What is a release arm.
Jul 13, 2014 at 12:16 PM
Avatar
SCHAZZAR
  • MEMBER
  • 5 POSTS
The firewall that the clutch cable on my car goes through calapsed inn. cable not held .i had a plate welded on for stength hold. lot of play. in cable. would that make a cllutch to not ingage.
Jul 13, 2014 at 12:34 PM
Avatar
HMAC300
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 48,601 POSTS
yup it's probably not able get adjusted correct hence it won't pull the clutch in the release arem is the throw out bearing arm to you
Jul 13, 2014 at 1:29 PM