1991 Chevrolet S 10

1991 CHEVROLET S-10
6 CYL • 4WD • AUTOMATIC
Avatar
LEIGHANN
  • MEMBER
  • 4 POSTS
LCD instrument pannel lights went out but MPH still showing is it a fuse or an electrical problem
Jan 17, 2011 at 12:23 AM
Advertisement
Avatar
HMAC300
  • ASE Certified Mechanic
  • 48,601 POSTS
  • ASE Certified Mechanic
check the fuse in teh fuse block first then check to see if the light switch is sending power to the ip. if all that does that then it may bethe lcd's.
Jan 17, 2011 at 1:44 AM
Avatar
LEIGHANN
  • MEMBER
  • 4 POSTS
I checked the fuses and there all good. I'm not sure how to check to see if the light switch is sending power to the insturment pannel.
Jan 17, 2011 at 6:24 PM
Avatar
LEIGHANN
  • MEMBER
  • 4 POSTS
I'd really like to see if i could just replace one of those little pieces in the motherboard thats behind it cause i don't want to pay to buy a whole new one if i can just figure out what the little problem is.
Jan 17, 2011 at 6:28 PM
Avatar
LEIGHANN
  • MEMBER
  • 4 POSTS
Cause i've noticed when i drive around they'll all the sudden come back on then sometimes when i'm driving they'll dim then go completely out so i'm wondering if the wires are grounding out somewhere
Jan 17, 2011 at 6:30 PM
Avatar
HMAC300
  • ASE Certified Mechanic
  • 48,601 POSTS
  • ASE Certified Mechanic
if you hit a bump and they goout and dim, then heck your grounds tot he dsh. there should be a black wire that is ground. to check the light switch you need a 12volt tester or dvom. you proble the wire that goes to the instrument panel
Jan 17, 2011 at 6:47 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.