brake light came on. pedal went to floor

1991 BUICK REGAL
10,600 MILES
Avatar
ARMS
  • MEMBER
  • 1 POST
checked reservoir and it didnt have any fluid. Filled it up and started car and pumped the brake pedal to find where the fluid was leaking from. must have pumped it fifty times. No leaks from lines or wheel cylinders. No fluid coming from master cylinder. Still have no brake pedal. Bleed master cylinder and still nothing. Pedal goes down to the floor. Still no leaks anywhere?
Sep 17, 2011 at 8:15 PM
Advertisement
Avatar
RIVERMIKERAT
  • ✓ASE Certified Mechanic
  • 6,110 POSTS
  • ASE Certified Mechanic
The fluid has to be going somewhere. If the master cylinder was empty, you need to bleed the whole system, not just the master cylinder. Start at right rear, move to left rear, then right front and left front. Make sure the master cylinder never completely drains or you'll have to start all over again. Bleed the cylinders.calipers until there are no air bubbles in the fluid stream.

If the system continues to drain after bleeding, check the rubber brake hoses to the cylinders/calipers and the diverter and proportioning valves for leaks. Also check the steel lines for leaks. Thoroughly clean the brake booster(what the master is bolted to) and check the rear seal of the master cylinder for leaks. Also, with the engine running, loosen the master cylinder to booster bolts and listen carefully for air hissing. If heard, the booster is leaking and needs to be replaced and has most likely sucked the master cylinder piston seal out.
Sep 17, 2011 at 8:27 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.