1990 Plymouth Acclaim transmission

5,500 MILES • 3.0L • V6 • FWD • AUTOMATIC
Avatar
ROGIEMAN
  • MEMBER
  • 2 POSTS
car will shift hard and bang and some times it will go into neutral so i stop shut off car and restart it then it is ok. it will not go into 4th or(od) and has a general slip code for 3-4 any possibility it could be some thing other than just dried out clutches? Trans module or controller or something
Feb 2, 2014 at 9:41 PM
Advertisement
Avatar
KNOWLEDGE IS POWER
  • EXPERT
  • 1,136 POSTS
these transmissions were notorious for control module problems. id start there
Feb 2, 2014 at 11:57 PM
Avatar
ROGIEMAN
  • MEMBER
  • 2 POSTS
Thank you did find an article on the a604 the short version is that the controller solenoid basically was needing a rebuild and that there is a kit for it. So i was thinking of trying that first. Is that the same as the module or is it some times called the transmission brain or controller
Feb 3, 2014 at 1:17 AM
Avatar
KNOWLEDGE IS POWER
  • EXPERT
  • 1,136 POSTS
the solenoid kit isn't the same as the module. the module controls the solenoids. but if thyre not too expensive you might just try them first. cars of this age are hard to diagnose in the best circumstances, but you wont do harm by changing these solenoids
Feb 3, 2014 at 2:55 AM
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle