Advertisement

wont start

150 MILES • 4 CYL • 4WD • MANUAL
Avatar
DLIZAR
  • MEMBER
  • 2 POSTS
i have a 1990 b2600i mazda.. changed fuel pump and filters and changed plugs cap and rotor with wires...it just backfires out the tail pipe...i did check to make sure wires were not crossed.. HELP....
Dec 17, 2010 at 2:33 PM
Advertisement
Avatar
RASMATAZ
  • ✓Experienced Mechanic
  • 75,988 POSTS
Do below to determine if its fuel or spark problem

Get a helper disconnect a sparkplug wire or 2 and ground it to the engine atleast 3/16 away from ground-have helper crank engine over-do you have a snapping blue spark? If so-you have a fuel related problem, Do you hear the fuel pump come On when you turn key on? If not check fuel pump fuse and fuel pump relay if so, check the fuel pressure to rule out the fuel filter/fuel pump/pressure regulator and listen to the injector/s are they pulsing or hook up a noid light. No snapping blue spark continue to troubleshoot the ignition system-power input to the coil/coil packs,coil's resistances,cap and rotor,distributor pick-up coil, ignition control module, cam and crank sensors and computer Note: If it doesn't apply disregard it and keep testing

Dec 17, 2010 at 2:48 PM
Advertisement
Avatar
DLIZAR
  • MEMBER
  • 2 POSTS
fuel pump comes on and there is great fuel pressure...spark at #1 plug is yellow not blue...
Dec 17, 2010 at 2:55 PM
Avatar
RASMATAZ
  • ✓Experienced Mechanic
  • 75,988 POSTS
Ignition is weak-test the ignition coil
Dec 17, 2010 at 2:58 PM
Advertisement
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle