1990 JEEP WANGLER YJ
104,000 MILES
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
I just replaced my starter and when we finished installing it, the jeep started right up. Then i proceded to shut it off and when i went to turn it back on, nothing happened. What could be the issue?
Apr 6, 2013 at 7:21 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
CARADIODOC
  • CAR REPAIR CONTRIBUTOR
  • 34,308 POSTS
You're asking why an entire system doesn't work. Pick any part in that system and it could be a suspect. What have you tested or checked to narrow it down? Does the starter relay click? If so, check the battery cables and the connection to the starter. If not, check the neutral safety switch. Does the starter solenoid click? What happens to the brightness of the head lights when you try to crank the engine?
Apr 6, 2013 at 7:42 PM
Advertisement