center motor mount discontenuied now what

1990 GEO STORM
66,500 MILES
Avatar
H-2 CHARLIE
  • MEMBER
  • 6 POSTS
it has a lite bang but not under a hard load anyways the motor mount has ben discontenuied i have looked for interchageable ones butT no luck . the dounut rubber can be swapped for a engery STIFF STYLE one but it might be to ruff ... ANY IDEAS ?
Nov 19, 2011 at 8:11 PM
Advertisement
Avatar
H-2 CHARLIE
  • MEMBER
  • 6 POSTS
not real close but i think i might have to pull it to be sure it might be here...
Nov 19, 2011 at 11:10 PM
Avatar
FIXITMR
  • ✓Experienced Mechanic
  • 9,990 POSTS
i ran into a similar problem bein a penny pincher i was thinkin after i got a used mount that id clean the old rubber out of the old mount and just fill with silicone and let cure till i needed it again. musta been too much work at the time and i let it go.
Nov 20, 2011 at 10:16 AM
Avatar
H-2 CHARLIE
  • MEMBER
  • 6 POSTS
Well after looking a found a rebuilder in the next town that does them in 1-3 hr and its only 25 for the frt dog bone and 35 for rhe rear these are the tq. ones the sides are fine ....MIGHTY MOUNTS IN Rosemead ca.
Dec 10, 2011 at 5:21 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.