electrical

1990 FORD BRONCO
145 MILES • 6 CYL
Avatar
NICKYBOTZ
  • MEMBER
  • 2 POSTS
battery was draining over night so i put a draw test on the battery. the light on my tester went out when i pulled out the fuse for hazards,cruise control and stop lights what next?
Feb 1, 2011 at 1:24 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
BMRFIXIT
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 19,053 POSTS
Next step is to isolate the circuit that fuse control
disconnect the cruise control and check for draw
Disconnect flasher and check ......
Feb 1, 2011 at 2:18 AM
Advertisement
Avatar
NICKYBOTZ
  • MEMBER
  • 2 POSTS
i did cruise control is ok unplugged the clip and still a draw
Feb 1, 2011 at 2:19 AM
Avatar
BLACKOP555
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 10,386 POSTS
what he means is unplug each item separately and different connectors until problem goes away. start at your brake and turn signals and disconnect the bulbs. draw still there? then pull the hazard flasher, if still a excessive draw there then pull the connector for cruise control on the actuator, if draw is stil there disconnect a connector farther up such as the brake switch. and so on and so forth
Feb 19, 2011 at 4:50 AM