electrical

1990 FORD BRONCO
145 MILES • 6 CYL
Avatar
NICKYBOTZ
  • MEMBER
  • 2 POSTS
battery was draining over night so i put a draw test on the battery. the light on my tester went out when i pulled out the fuse for hazards,cruise control and stop lights what next?
Jan 31, 2011 at 5:24 PM
Advertisement
Avatar
BMRFIXIT
  • ✓Experienced Mechanic
  • 19,053 POSTS
Next step is to isolate the circuit that fuse control
disconnect the cruise control and check for draw
Disconnect flasher and check ......
Jan 31, 2011 at 6:18 PM
Avatar
NICKYBOTZ
  • MEMBER
  • 2 POSTS
i did cruise control is ok unplugged the clip and still a draw
Jan 31, 2011 at 6:19 PM
Avatar
BLACKOP555
  • ✓Experienced Mechanic
  • 10,386 POSTS
what he means is unplug each item separately and different connectors until problem goes away. start at your brake and turn signals and disconnect the bulbs. draw still there? then pull the hazard flasher, if still a excessive draw there then pull the connector for cruise control on the actuator, if draw is stil there disconnect a connector farther up such as the brake switch. and so on and so forth
Feb 18, 2011 at 8:50 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.