Brakes go to floor when motor is cranked

1990 CHEVROLET TRUCK
190 MILES
Avatar
SLAPOUT
  • MEMBER
  • 1 POST
replaced leaking rear wheel cylinders, shoes, and drums.After bleeding until no bubbles, and firm pedal, started engine and the pedal dropped almost to the floor.Bled more.Had small leak under reservoir, so I replaced master cylinder.Bled more.Have firm pedal, till I start the engine.Bled master,bled all 4 brakes,again. So far used 3 qt,s of fluid.Can it be the ABS hydraulic unit? Pedal is firm and does not drop until I start it up.
Dec 8, 2011 at 1:52 AM
Advertisement
Avatar
DRCRANKNWRENCH1
  • ✓ASE Certified Mechanic
  • 3,435 POSTS
  • ASE Certified Mechanic
The brake booster is bad.
Dec 8, 2011 at 2:00 AM
Avatar
HOMER1967
  • ✓ASE Certified Mechanic
  • 875 POSTS
  • ASE Certified Mechanic
you have a bypassing brake booster.you need a new one.
Dec 8, 2011 at 2:06 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.