Car crank no start changed crank sensor and ignition control I still have no fire what could it be
Saturday, August 30th, 2014 AT 8:13 AM
8 Replies
HMAC300
MECHANIC
48,601 POSTS
See pic also check fuses tach wire is blk/wht
Image (Click to make bigger)
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Saturday, August 30th, 2014 AT 9:41 AM
CIAO75BELLA
MEMBER
4 POSTS
New crank sensor new ignition module still spark ignition module has power sensor ohms out still no spark only thing haven't checked is tack writes or pulled coils off to check
Was this
answer
helpful?
Yes
No
Saturday, August 30th, 2014 AT 10:11 AM
HMAC300
MECHANIC
48,601 POSTS
Di you red what I sent in the pic on how to diagnose it? If thetach is shorted out the car won't start so pull tach wire like it says in instructions I sent albeit small
Was this
answer
helpful?
Yes
No
Saturday, August 30th, 2014 AT 10:13 AM
CIAO75BELLA
MEMBER
4 POSTS
Thank you for your assistance Working on that now if it isn't the track wire any other suggestions? Is it possible that all 3 coil packs could go bad at the same time?
Was this
answer
helpful?
Yes
No
Saturday, August 30th, 2014 AT 10:18 AM
HMAC300
MECHANIC
48,601 POSTS
I'd say igniter not the coils or it'snot hooked up right. Scan for codes see if you get anything there.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Saturday, August 30th, 2014 AT 10:20 AM
CIAO75BELLA
MEMBER
4 POSTS
Checked everything had a bad ground fixed that started right up ran it up and down the street. Went out layer started right up and ran about a mile kept shutting off and now is cranking again but won't start I may don't understand
Was this
answer
helpful?
Yes
No
-1
Monday, September 1st, 2014 AT 6:55 PM
HMAC300
MECHANIC
48,601 POSTS
Don't know what to tell you I have no further comments