1990 CADILLAC ELDORADO
109,000 MILES
Avatar
CHELSIE82PDX
  • MEMBER
  • 1 POST
I was told I need to replace the Engine control module so I went and bought one. I need to know if there is any special procedures when replacing it or any info you can tell me on reseting the codes but keeping the same programing. Thank you!
Oct 25, 2012 at 8:22 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
WRENCHTECH
  • CAR REPAIR CONTRIBUTOR
  • 20,761 POSTS
You won't have to reset any codes because you are removing the entire ECM that holds the codes. You will have to swap over the PROM from your old ECM. https://www.2carpros.com/images/external/57467514.gif
Oct 25, 2012 at 9:44 AM
Advertisement