1989 Pickup clutch problem

Tiny
JETTERHEADER
  • MEMBER
  • 1989 TOYOTA PICKUP
  • 4WD
  • MANUAL
Hi, have a 1989 SR5 4x4, 4 cyc, 22R 5 sp with 71K on it. Replaced the shifter bushing and seat but when coming to a stop, truck seems to slip into gear causing a learching of the vehicle. Not sure where to look next. Any ideas? Thanks, Jean
Tuesday, August 2nd, 2011 AT 1:52 PM

8 Replies

Tiny
WRENCHTECH
  • MECHANIC
  • 20,761 POSTS
How does a manual transmission "slip" into gear?
Was this
answer
helpful?
Yes
No
Tuesday, August 2nd, 2011 AT 2:06 PM
Tiny
JETTERHEADER
  • MEMBER
  • 6 POSTS
Sorry. I am new to this site. Are you suggesting that I go to a section on this site titled "How des a manual trans slip into gear"? Thanks for responding so fast too.
Was this
answer
helpful?
Yes
No
Tuesday, August 2nd, 2011 AT 2:16 PM
Tiny
WRENCHTECH
  • MECHANIC
  • 20,761 POSTS
No, I am asking you how a manual transmission can simply "slip into gear" by itself. Never seen it happen in my life and I'm not young.
Was this
answer
helpful?
Yes
No
Tuesday, August 2nd, 2011 AT 2:20 PM
Tiny
JETTERHEADER
  • MEMBER
  • 6 POSTS
Yea I know. It is really weird. Took truck out for a test drive yesterday and friend were with me and saw it happen.I do put it into neutral as I approach a stop and when truck slows down, almost at a crawl, the truck jumps like in 1st.I dont do anything to the stick or clutch pedal, so its really weird. With the new parts, the shift stick seems to go into gear much better, like detending smooth. But this problem is really strange. There is no clutch pedal adjustment that I can find. I was thinking of check the gear oil but I dont think that is a fix. Sigh
Was this
answer
helpful?
Yes
No
Tuesday, August 2nd, 2011 AT 2:25 PM
Tiny
JETTERHEADER
  • MEMBER
  • 6 POSTS
Wonder if a brake is hanging up. Was thinking of that too, but never had brake problems. I know the truck is old.I am not a kid either. Ha.
Was this
answer
helpful?
Yes
No
Tuesday, August 2nd, 2011 AT 2:26 PM
Tiny
WRENCHTECH
  • MECHANIC
  • 20,761 POSTS
Sou8nds like you just have a worn out transmission.
Was this
answer
helpful?
Yes
No
Tuesday, August 2nd, 2011 AT 2:35 PM
Tiny
JETTERHEADER
  • MEMBER
  • 6 POSTS
Hope not. Going to try and change the way I drive. As it always responds when I go into gear, thru all speeds. The trans seems strong in all phases. If doesn't happen all the time, just once in a while. Maybe freewheeling to a stop is not a good thing. I do thank you for your responses. Will advise if I findout when the problem is.
Was this
answer
helpful?
Yes
No
Tuesday, August 2nd, 2011 AT 2:46 PM
Tiny
JETTERHEADER
  • MEMBER
  • 6 POSTS
Dud. Found the problem.A wheel cyclinder has been hanging up, only once in a while. Guess I mis-read what was actually happening. But the truck being 23 years old, things wear out! Thanks again for your responses as that kept me searching for the problem.
Was this
answer
helpful?
Yes
No
Tuesday, September 13th, 2011 AT 4:51 PM

Please login or register to post a reply.

Sponsored links