89 nissian pulsar

1989 NISSAN PULSAR
215,000 MILES
Avatar
NATER567
  • MEMBER
  • 1 POST
how do i adjust the idle on 89 nissian pulsr? i have turned the screw on the computer and all i get is a flashing lights a red and greed along with the check engine light flashing please help
Mar 3, 2011 at 3:42 PM
Advertisement
Avatar
KHLOW2008
  • ✓Experienced Mechanic
  • 41,812 POSTS
4-Cylinder Idle Speed: Pulsar NX SE, Stanza & 240SX

1. Start and warm engine to normal operating temperature. Run engine at about 2000 RPM for 2 minutes under no load. Race engine 2 to 3 times and let idle for one minute.
2. Check idle speed in Drive on automatic transmission models. Ensure idle speed is below 800 RPM. Adjust idle speed. Disconnect Auxiliary Air Control (AAC) valve harness connector. Disconnect throttle valve sensor/switch harness connector. Adjust idle speed by turning adjusting screw on Idle Air Adjusting (IAA) unit. See Fig. 3. Reconnect harness connectors and recheck idle speed.


© 2008 Mitchell Repair Information Co., LLC.
Image (Click to enlarge)
Attached Media
Mar 3, 2011 at 4:04 PM
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Ask a new question

Frequently Asked Problems for This Vehicle