89 nissian pulsar

1989 NISSAN PULSAR
215,000 MILES
Avatar
NATER567
  • MEMBER
  • 1 POST
how do i adjust the idle on 89 nissian pulsr? i have turned the screw on the computer and all i get is a flashing lights a red and greed along with the check engine light flashing please help
Mar 3, 2011 at 11:42 PM
Advertisement
Avatar
KHLOW2008
  • ✓ASE Certified Mechanic
  • 41,814 POSTS
  • ASE Certified Mechanic
4-Cylinder Idle Speed: Pulsar NX SE, Stanza & 240SX

1. Start and warm engine to normal operating temperature. Run engine at about 2000 RPM for 2 minutes under no load. Race engine 2 to 3 times and let idle for one minute.
2. Check idle speed in Drive on automatic transmission models. Ensure idle speed is below 800 RPM. Adjust idle speed. Disconnect Auxiliary Air Control (AAC) valve harness connector. Disconnect throttle valve sensor/switch harness connector. Adjust idle speed by turning adjusting screw on Idle Air Adjusting (IAA) unit. See Fig. 3. Reconnect harness connectors and recheck idle speed.


© 2008 Mitchell Repair Information Co., LLC.
Image (Click to enlarge)
Professional Diagram for 2CarPros Members
Click here to log in and view diagram.
Mar 4, 2011 at 12:04 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.