1989 Mazda 929 Remove Expansion Valve On

1989 MAZDA 929
133,000 MILES
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
HOw do I remove the expansion valve on a 1989 Mazda 929
Jan 7, 2013 at 8:44 PM
Advertisement
Avatar
ASEMASTER6371
  • ✓Experienced Mechanic
  • 52,796 POSTS

Disconnect battery ground cable, then discharge refrigerant from cooling system.
Disconnect intake and discharge lines from cooling unit fittings.
Remove grommets from expansion valve.
Remove shower duct.
Remove I/P lower panel, then glove box.
Remove blower duct.
Remove sealing plates from evaporator unit, Fig. 2.
Disconnect A/C wiring harness from evaporator unit.
Remove drain hose, unit retaining nuts, then evaporator unit.
Reverse procedure to install.

it is in the evap case.

Roy
Jan 8, 2013 at 1:18 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.