1989 Dodge Colt colt vista -no fire

1989 DODGE COLT
121,000 MILES
Avatar
DREADNAUGHT
  • MEMBER
  • 3 POSTS
No fire -new ignitor transistor,new ignition control module.
voltage seen through computer to ignitor,but ignitordoesnotblink when ignition on start..getting fuel at injectors ok..

continuity ok on all distributor wires leading to computer. Current ok to distributor with switch at ON.
Aug 25, 2013 at 3:31 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
JACOBANDNICKOLAS
  • CAR REPAIR CONTRIBUTOR
  • 110,190 POSTS
Are you getting any spark from the coil wire?
Aug 25, 2013 at 7:41 PM
Advertisement
Avatar
DREADNAUGHT
  • MEMBER
  • 3 POSTS
no spark at coil wire but current flowing to coil from multipurpose relay. Again , no blinking on START at igniter, just continuous current showing on test light at that point. igniter does not seem to be activating coil.to spark.
Aug 25, 2013 at 10:38 PM
Avatar
JACOBANDNICKOLAS
  • CAR REPAIR CONTRIBUTOR
  • 110,190 POSTS
Is the distributor turning when you crank the engine?
Aug 26, 2013 at 8:16 PM
Avatar
DREADNAUGHT
  • MEMBER
  • 3 POSTS
Yes the distributer is turning..
Aug 28, 2013 at 9:09 PM