1989 Chevrolet Celebrity steering

1989 CHEVROLET CELEBRITY
150,000 MILES
Avatar
DOPEHEAD
  • MEMBER
  • 1 POST
Try to remove the rack and pinion but bolt on pasenger side is to long keeps hiting floor board of the car it needs to come out at least another inch or so is that a normal how can i remove it does the motor and transmission need to be removed to drop tle lower frame just for one bolt?
Jul 14, 2013 at 11:44 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
JDL
  • CAR REPAIR CONTRIBUTOR
  • 16,098 POSTS
The last one of these I did, was an 88 celeb 2.8L engine. I used a floor jack and lowered the rear of the cradle about 3 or 4 inches, I wouldn't lower it any further than that. My info shows two bolts holding rear of cradle.

If you see a better way, go for it. Good luck.
Jul 14, 2013 at 12:57 PM
Advertisement