Where is the nurser switch on a 1989 Camero located? Any ideas as to what I'am doing wrong?

1989 CHEVROLET CAMARO
131,000 MILES
Avatar
ASHLEY77872009
  • MEMBER
  • 1 POST
I have changed the steering colum but I put the key switch out of the old colum in the new one and know it wont crank over. But the turn signal work and the lighs work but I don't hear the fuel pump coming on. Any ideas on what I might be doing wrong?
May 19, 2012 at 7:44 PM
Advertisement
Avatar
ASEMASTER6371
  • ✓Experienced Mechanic
  • 52,796 POSTS
make sure the connector on the ignition switch are good and tight

Roy
May 19, 2012 at 7:49 PM
Avatar
RASMATAZ
  • ✓Experienced Mechanic
  • 75,992 POSTS
If you're talking about inertia switch it doesn't come with it-Double check the ignition switch as suggested if okay-check the fuel pump relay
May 19, 2012 at 7:56 PM
Avatar
CADIEMAN
  • ✓Experienced Mechanic
  • 3,544 POSTS
check for start signal is being sent from the ingition switch whyll the key is in start poss.if yes check for it at the starter.
May 19, 2012 at 8:28 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.