1989 Chevrolet Blazer throttle body injection

1989 CHEVROLET BLAZER
120,000 MILES
Avatar
70CJ
  • MEMBER
  • 2 POSTS
i recently did a body swap on a k5 replacing the blazer body with a 1970 cj5 i cut 4ft off the rear of the frame and installed a new fuel tank and ran new lines filter, everything. the CPU is hooked up and i used wiring diagrams to wire the ignition system. now the fuel is making a round trip back to the tank and the engin still wont crank over. ive already cleaned the injectors.
Sep 2, 2013 at 12:44 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
JACOBANDNICKOLAS
  • CAR REPAIR CONTRIBUTOR
  • 110,190 POSTS
If the fuel is running directly back to the fuel tank, it sounds like the regulator is bad. Have you checked that?
Sep 2, 2013 at 6:30 PM
Advertisement
Avatar
70CJ
  • MEMBER
  • 2 POSTS
It doesn't use a fuel regulator my best guess is that I might have to clean the tbi it ran when the project began about 3 months ago
Sep 2, 2013 at 10:05 PM
Avatar
JACOBANDNICKOLAS
  • CAR REPAIR CONTRIBUTOR
  • 110,190 POSTS
How are you regulating fuel pressure? If the fuel is running back to the tank, there will be little to no fuel pressure at the rail.
Sep 3, 2013 at 6:17 PM