1988 Mazda Mx6 Last Winter Used Heater Sometimes Noticed Antifreeze Smell This

1988 MAZDA MX6
269,000 MILES
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
Last winter when I used the heater I sometimes noticed an antifreeze smell. This winter apparently the heater core sprung a big leak because when I first noticed it, half the floor was wet but I didn't realize at the time why. Well now its time for the car to go to the shop for appointment made 3 wks ago and I'm checking my fluids under the hood and find out the radiator is a qt low. I add the water, start the car to warm it up and run the heat on high to warm the cab for the drive. After a bit I shut it off and then when ready to leave, by mere chance, I noticed the passenger floor and mat are litterally standing in water. Now for my question, I have no way to tow my car, I know that the heater core can be bypassed but I dont really know the first thing about reaching and removing those hoses and with a bad back I dont want to attempt it.--So if I refill my radiator, and put the heater control on off with the temp all the way over to the cold side and fan off. can I drive the car to the shop or will I still lose water thru the bad core?
Thank You Much as this is stressing me out.
Dec 15, 2012 at 8:40 AM
Advertisement
Avatar
KHLOW2008
  • ASE Certified Mechanic
  • 41,814 POSTS
  • ASE Certified Mechanic
You would still lose coolant even if the heater valve is closed as the return hose from heater core is open at all times. Close the heater valve and clamp the return hose if you have sufficient length of heater hose to be clamped.

Dec 16, 2012 at 9:49 AM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.