92' Jeep 4.0 6 cyl

1988 JEEP COMANCHE
100 MILES • 6 CYL • 4WD • MANUAL
Avatar
JMLEACH
  • MEMBER
  • 2 POSTS
I have a 92 jeep 4.0 cylinder. I have had some issues with the clutch. I was driving and down shifted a gear. There was a shearing/ popping sound, then the truck died and would not turn over.Some thing blew out a small hole n the bell housing. That was fixed, but now I have no spark on the 1st and 6th cylinder. Drive train is good. Maybe a bad sensor or a problem with the distributer?? HELP. I'm stumped. any theory's would be greatly appreciated.; The engine is n a 88' jeep Comanche. THANX
Nov 17, 2010 at 8:43 PM
Advertisement
Avatar
JACOBANDNICKOLAS
  • ✓Experienced Mechanic
  • 110,240 POSTS
Have you checked the crank sensor?
Nov 17, 2010 at 8:55 PM
Avatar
JMLEACH
  • MEMBER
  • 2 POSTS
yes, first thing.
Nov 17, 2010 at 10:27 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.