How do you adjust timing on a 1988 Bronco 2? 2.9L Fuel injected
Nov 24, 2010 at 10:19 AM
Timing 88 Bronco II
JOSHCODY76
- MEMBER
- 1 POST
Advertisement
1. Place transmission in Neutral or Park with A/C in off position.
2. Connect an inductive timing light.
3. Disconnect the single wire in-line spout connector or remove the shorting bar from the double wire spout connector.
4. Start engine and allow to reach operating temperature. With engine at timing rpm,in check or adjust initial timing to specification.
5. Reconnect single wire in-line spout connector or reinstall the shorting bar on the double wire spout connector. Check timing advance to verify distributor is advancing beyond the initial setting. If it is not, refer to QUICK TEST COMPUTERIZED ENGINE CONTROLS
6. Remove test instruments.
2. Connect an inductive timing light.
3. Disconnect the single wire in-line spout connector or remove the shorting bar from the double wire spout connector.
4. Start engine and allow to reach operating temperature. With engine at timing rpm,in check or adjust initial timing to specification.
5. Reconnect single wire in-line spout connector or reinstall the shorting bar on the double wire spout connector. Check timing advance to verify distributor is advancing beyond the initial setting. If it is not, refer to QUICK TEST COMPUTERIZED ENGINE CONTROLS
6. Remove test instruments.
Nov 24, 2010 at 10:42 AM
🔧 Tools & Auto Repair Parts
Find automotive tools, diagnostic equipment, and replacement
parts for your next repair.
Shop on Amazon →
Paid affiliate link. As an Amazon Associate, we earn from qualifying purchases.