1988 Ford Bronco No crank

5.0L • V8 • 4WD • AUTOMATIC
Avatar
BABYLOVE
  • MEMBER
  • 1 POST
Hi, I have a no crank problem. I bought a new starter and solenoid and now a buzz at solenoid and still no crank.
Feb 23, 2015 at 4:46 AM
Advertisement
Avatar
CARADIODOC
  • ✓Experienced Mechanic
  • 34,414 POSTS
A loud buzzing from the solenoid is due to low voltage. Start by measuring the battery voltage. It will be 12.6 volts if it's good and fully-charged. Measure it again, right on the posts, not the cable clamps, while a helper tries to crank the engine. If it drops below about ten volts, replace the battery.

If the voltage stays fairly high, move the positive meter probe from the battery's post to the cable clamp and measure again during the attempted cranking. Now move the negative probe from the post to the cable clamp and try again. You're looking for a point at which the voltage drops noticeably. That is the point of the loose or dirty connection.
Feb 23, 2015 at 4:52 AM
Add a reply
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.

Frequently Asked Problems for This Vehicle