Serpentine belt diagrams

Tiny
GBULLDOG
  • MEMBER
  • 1988 CADILLAC FLEETWOOD
Belt diagram for a 1988 Cadillac Brougham?
Thursday, December 16th, 2010 AT 6:07 PM

3 Replies

Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
Here is a guide and the diagrams below so you can see how the job is done:

https://www.2carpros.com/diagrams/cadillac/fleetwood/1989

Check out the diagrams (below). Please let us know if you need anything else to get the problem fixed.

Cheers
Was this
answer
helpful?
Yes
No
-2
Thursday, December 16th, 2010 AT 6:26 PM
Tiny
MRMIKE1
  • MEMBER
  • 1 POST
  • 1989 CADILLAC FLEETWOOD
  • 200 MILES
Bolt has been tightened and the belt is still loose and squalling. Need to tighten the tension, but cannot find a way to adjust it or a place to pry against. What do you pry on to adjust the tension on power steering belt. There is not a serpentine belt. There are four separate belts on the 1989 Fleetwood Brougham RWD.
Was this
answer
helpful?
Yes
No
Thursday, September 27th, 2018 AT 3:24 PM (Merged)
Tiny
CADILLACMAN28
  • MEMBER
  • 10 POSTS
To tighten the power steering belt. I just set my ratchet with a 15 millimeter inside one of the three holes in the pulley on the bolt. It is at the top of the pump and towards the drivers side you have to line the hole on the pulley with the bolt. Loosen that then there a bolt on the backside of the power steering pump towards the bottom that has to be loosened also then another underneath the pulley also driver side bottom. Loosen all three then use your right hand and tighten the first bolt with the ratchet in your left hand. Do not pry against the pump. You will bend it up. I just replaced mine and bent the heck out of the new one. Had to take it back. Try that hope it helps.
Was this
answer
helpful?
Yes
No
+1
Thursday, September 27th, 2018 AT 3:24 PM (Merged)

Please login or register to post a reply.

Sponsored links