noise when engine is running

1987 JEEP WANGLER YJ
6 CYL • 4WD • MANUAL
Avatar
JEEPLAXER28
  • MEMBER
  • 1 POST
new clutch, flywheel and starter have been installed on a jeep wrangler. there is a loud scraping noise coming from the bell housing when i start it up. i suspect the starter is not disengaging because that's what it sounds like and there are no vibrations with it. any other possible ideas what could be causing this?
Jan 30, 2011 at 3:00 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
CJ MEDEVAC
  • CAR REPAIR CONTRIBUTOR
  • 11,004 POSTS
Does the sound stop after you release the key?

Have you tried another starter?

Starter shims?

Stupid things happen, so do not be ASTONISHED, if you wind up with something really stupid!.........Like a wrench left in it!

Your Turn

The Medic
Jan 30, 2011 at 10:38 PM
Advertisement