1987 Ford Ranger distributor hold down

1987 FORD RANGER
200,000 MILES
Avatar
LPETER
  • MEMBER
  • 1 POST
Good morning,
I have been having difficulties locating the distributor hold down bolt on my ford ranger 1987. I swear it is non-existent!! Any advice on how to find it? We have tried numerous times looking at different angles and are still unable to locate it. The engine space is quite limited and is very difficult to see. We looked from below, from bird's eye view and we even dismantled the air filter in the hopes to get a better look.
Jun 12, 2013 at 9:11 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
DOCFIXIT
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 18,828 POSTS
What engine?
Jun 12, 2013 at 9:15 AM
Advertisement
Avatar
JDL
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 16,098 POSTS
Just a thought. Have you tried using a flashlite and a mirror to illuminate the base of distributor? With a tight fitting area, it can be trying to get the mirror in the right position. Shine the fashlite into the mirror.

I was trying to butt-in, just killing time.
Jun 12, 2013 at 10:39 AM
Avatar
JDL
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 16,098 POSTS
let me rephrase, I WASN'T trying to butt-in. Sometimes, my mind and my typing don't work at the same speed.
Jun 12, 2013 at 10:41 AM