Thee may be a paper tag on the computer itself, you may have wha is called aprom inside that is to be put in new computer. If theprom is bad then you'll have to find one and good luck on that as the car hasn't been made in so some years.
SPARK CONTROL COMPUTER
Removal
Remove negative battery terminal. Disconnect 10-pin and 14-pin connectors from computer. Remove vacuum hose from vacuum transducer. Remove mounting screws from inside air cleaner and remove computer.
Do not remove grease from harness connectors or connector terminals in computer. Grease is used to prevent moisture from corroding terminals.
Installation
If there is not at least 1/2 "of grease on bottom of computer connector terminals, apply a liberal amount of multipurpose grease (Mopar No. 2932524) over entire end of plug before reinstalling. Reverse removal procedure to complete installation
Wednesday, April 23rd, 2014 AT 1:20 PM