after puting new head gasket two times to make sure it was ok where geting
Aug 27, 2012 at 10:48 AM
put new head gasket on now its blowing water out the over flow its geting way to much water presure
JUANCISNEROS
- MEMBER
- 2 POSTS
You still compression leak. Was the cylinder refaced? Did you check the engine block surface for uneveness?
Aug 27, 2012 at 11:00 AM
no it was not refaced but there was no marks or any damage that i could see . Would it get that much presure because of something like that it has a lot it dont even have to start and it will all most blow the cap off the radiator
Aug 27, 2012 at 11:41 AM
The head does ot have to have any marks. If it is warped, it is not going to be seated flat on the gasket and this would result in compression leakages as the gaskets are not sealing correctly.
Aug 27, 2012 at 12:13 PM
how would you know if the head is warped
Aug 27, 2012 at 12:15 PM
You need to send it to the machine shop to have it measured.
Aug 27, 2012 at 2:27 PM
🔧 Tools & Auto Repair Parts
Find automotive tools, diagnostic equipment, and replacement
parts for your next repair.
Shop on Amazon →
Paid affiliate link. As an Amazon Associate, we earn from qualifying purchases.