windshield wiper motor

1986 FORD BRONCO
90,000 MILES • 6 CYL • 4WD • AUTOMATIC
Avatar
SUEHASKINS
  • MEMBER
  • 1 POST
replace a windshield wiper motor
Mar 21, 2011 at 3:37 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
FIXITMR
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 9,990 POSTS
with a car that old, you should buy a repair manual.
Mar 21, 2011 at 3:45 PM
Advertisement
Avatar
MARTIN SAVARD
  • MEMBER
  • 7 POSTS
Cycle the wipers until they are straight up position, turn ignition off. Disconect the battery. Remove right hand wiper arm and blade assembly. Let Linkage drop into the cowl then remove the linkage access cover from right hand side of dash panel. release wiper motor retaining clip and slide the clip back until it clears nib on crank pin. The retaining clip can be reached through the access cover opening. remove wiper linkage from motor crank pin. Disconect electrical connector from wiper motor, then remove motor attaching screws and the motor. Reverde procedure to insatall

This information is from Alldata service Program Hope it helps
Mar 21, 2011 at 5:43 PM