location of the ignition control module

1986 DODGE RAMCHARGER
Avatar
SMITH RYAN
  • MEMBER
  • 1 POST
location of ignition control module in a 1986 dodge ramcharger with a 318
Apr 11, 2012 at 8:22 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
JACOBANDNICKOLAS
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 110,190 POSTS
on the passenger side of the engine compartment, look at the post and image below.

Best, Joe
Image (Click to enlarge)
Attached Media
Apr 11, 2012 at 8:40 PM
Advertisement
Avatar
STRAILER
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 54,178 POSTS
Hey SMITH,

I looks like it is on the passenger side of the engine compartment or down low on the firewall on the drivers side , here are diagrams for you to help get the problem fixed.

Check out the diagrams (Below). Please let us know if you need anything else to get the problem fixed.

Cheers, Ken
Images (Click to enlarge)
Attached Media
Attached Media
Feb 28, 2017 at 3:49 PM
Avatar
M MORTON
  • MEMBER
  • 1 POST
where is the ignition module located on a 87 dodge ramcharger
Feb 28, 2017 at 3:50 PM (Merged)
Avatar
TRACY CROCKETT
  • MEMBER
  • 1 POST
I cannot find the ignition control module anywhere along the fire wall. Where is it exactly located?
Feb 28, 2017 at 3:50 PM (Merged)
Avatar
HMAC300
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 48,601 POSTS
see picture. it may be on the fender-well between washer fluid tank and firewall. also, check ballast resistor as that used to a big problem especially if when you crank it fires then quits when you let off.
Image (Click to enlarge)
Attached Media
Feb 28, 2017 at 3:50 PM (Merged)