I need to find out how to get the trouble codes for my 1986 Blazer.

1986 CHEVROLET BLAZER
260,000 MILES
Avatar
KARLSBEACHTOWN831
  • MEMBER
  • 2 POSTS
How do I get the trouble codes to come up in the instrument panel? Can I turn the ignition over a certain times to get the warning to flash a code on the speedometer panel?

Sep 5, 2011 at 3:44 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
CARADIODOC
  • CAR REPAIR CONTRIBUTOR
  • 34,308 POSTS
That simple ignition switch procedure is for Chrysler products. For yours, find the diagnostic connector under the steering column, connect terminals "A" and "B", then turn on the ignition switch and count the flashes of the Check Engine light. Terminals A and B are the two right next to each other in one corner.
Sep 5, 2011 at 3:50 AM
Advertisement