my rocker arms don't have an adjusting screw/bolt, how do i set the tappet clearance?

1985 TOYOTA
70,000 MILES
Avatar
DANIEL LEARY
  • MEMBER
  • 2 POSTS
i've just replaced a head gasket and a cracked head an my 85 toyota hilux 3y engine and i'm up to setting the tappets, but there's no bolt/screw or anythin g like that to set it with.
Jun 1, 2012 at 12:34 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
ASEMASTER6371
  • CAR REPAIR CONTRIBUTOR
  • 52,796 POSTS
i believe they are set with shims. who dis assmbled the head?? did you remove shims??

roy
Jun 1, 2012 at 12:43 AM
Advertisement
Avatar
DANIEL LEARY
  • MEMBER
  • 2 POSTS
i did, and there weren't any. if i do up the nuts that hold on the rocker anywhere past fingertight there isn't any clearance at all.
Jun 1, 2012 at 2:45 AM