1985 Chevrolet Blazer Replace Clutch Slave Hydraulic 2wd 4 Cyl

1985 CHEVROLET BLAZER
200,000 MILES
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
Please Help! How do I replace a clutch slave hydraulic in a 1985 2WD- 4 cyl blazer? Be gentle, I don't know too much about this. Thank You!!
Nov 21, 2012 at 6:26 AM
Advertisement
Avatar
HMAC300
  • ✓ASE Certified Mechanic
  • 48,601 POSTS
  • ASE Certified Mechanic
take out two bolts and line aholding it, cap the line. Have new slave and hook up but don't bolt up to engine. hold cylinder on a 45 degree angle with bleeder screw at highest point. have a helper push clutch in an dhold it. bleed until all air is out. then put back in place.
Nov 21, 2012 at 2:59 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.