how too remove
Feb 26, 2011 at 4:47 PM
ingnitin switch
1984 MERCEDES BENZ 300SD
HARRY414
- MEMBER
- 2 POSTS
- FOLLOW
Repair Safety Notice:
This information is for general instructional purposes only. Vehicle repair can be dangerous.
Verify all information, follow manufacturer service procedures, use proper tools and safety equipment,
and consult a qualified repair shop when needed.
Advertisement
how too remove
Feb 26, 2011 at 4:49 PM
Removal and Installation of Ignition/Starter Switch:
1.Turn ignition key to position "1" (arrow ).
2.Disconnect plug connector (20 ) on ignition/starter switch (S2/1 ), reconnect.
3.Remove mechanical part of steering wheel lock (1 ), install. See: Starting and Charging\Starting System\Ignition Lock\Service and Repair
4.Screw ignition/starter switch (S2/1 ) out of steering wheel lock (1 ), screw in, pull out, insert. Insert ignition/starter switch (S2/1 ) so that locating lug (arrow) engages in recess in steering wheel lock (1 ).
5.Check ignition/starter switch (S2/1 ) for proper function.
1.Turn ignition key to position "1" (arrow ).
2.Disconnect plug connector (20 ) on ignition/starter switch (S2/1 ), reconnect.
3.Remove mechanical part of steering wheel lock (1 ), install. See: Starting and Charging\Starting System\Ignition Lock\Service and Repair
4.Screw ignition/starter switch (S2/1 ) out of steering wheel lock (1 ), screw in, pull out, insert. Insert ignition/starter switch (S2/1 ) so that locating lug (arrow) engages in recess in steering wheel lock (1 ).
5.Check ignition/starter switch (S2/1 ) for proper function.
Image (Click to enlarge)
Mar 20, 2011 at 11:25 PM
Advertisement