how to replace dash lights

1984 FORD E-SERIES VAN
171,000 MILES
Avatar
DIESEL DUCK
  • MEMBER
  • 3 POSTS
I have removed the insturment panel, but I don't know how to remove the speedometer cable to acess the light bulbs,and, how can I safely re-align it for re-installation?
Nov 29, 2011 at 8:40 PM
Advertisement
Avatar
RIVERMIKERAT
  • ✓Experienced Mechanic
  • 6,110 POSTS
The speedo fitting is threaded. It unscrews-counterclockwise.
The bulbs are removed by turning the pigtail 1/4 turn counterclockwise.
The speedo cable is self-aligning.
Nov 29, 2011 at 8:55 PM
Avatar
DIESEL DUCK
  • MEMBER
  • 3 POSTS
Im familiar with the type of threaded speedo cap you mentioned.However the one that's connecting my cable is a plastic unit that seems to have some method of release. But I can only see part of it.If I knew how it worked I may be able to diconnect it by feel.
Nov 30, 2011 at 2:26 PM
Avatar
RIVERMIKERAT
  • ✓Experienced Mechanic
  • 6,110 POSTS
Oh. Ok. It snaps in and two clips on either side of the cable end housing clip over a lip on the back of the speedo. To release it, you need to firmly squeeze the cable end 90 degrees out from the latch clips.
Nov 30, 2011 at 7:16 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.