where is the number 1 position on a round rotor

1981 LINCOLN TOWN CAR
Avatar
JIMMYLEEGILBERT
  • MEMBER
  • 1 POST
Dist cap?how do i find the correct firing order by one plug at a time? replaced timing chain and gears,new dist cap rotor.ford firing orders does not match.not sure that someone replaced distributor shaft with a different one.
Feb 22, 2012 at 9:22 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
FIXITMR
  • CAR REPAIR CONTRIBUTOR
  • 9,990 POSTS
#1 piston TDC look at rotor position. start #1 plug wire there and the rest in firing order in direction of rotation of rotor.
Feb 22, 2012 at 9:40 PM
Advertisement
Avatar
CJ MEDEVAC
  • CAR REPAIR CONTRIBUTOR
  • 11,004 POSTS
KEEP IN MIND THE "NORM" OR FACTORY/ BOOK PICTURE IS NOT ALWAYS HOW IT CAN BE SET UP......DEPENDING ON WHO INSTALLED THE DISTRIBUTOR, #1 COULD BE IN ANY POSITION!.......AND THAT DOESN'T MEAN IT'S WRONG!!!.....WHEN YOU DO FIND TDC, AND WHERE #1 IS POINTING, LIKE fixitmr SAID, THAT'S WHERE THE START OF THE FIRING ORDER SEQUENCE WILL BEGIN

THE BEGINNING OF THIS THIS WILL NOT APPLY TO YOU....IT IS GOOD INFO REGARDLESS...THE REST MAY HELP YOU WITH "TDC"

http://www.youtube.com/watch?v=5a2X9mSSlQY (PART 1)



http://www.youtube.com/watch?v=FHX1yXVyIMg&feature=related (PART 2)

LET US KNOW HOW IT'S GOING

THE MEDIC
Feb 25, 2012 at 2:22 PM