I just got back from Iraq and my Jeep has been set up for about 6 months. When I left it worked just fine. I came home and found wires undone(which some were anyway). I was not getting any juice at all. I replaced my cylinode. I also replaced or repaired the pos/neg wiring and battery. I can now get some juice but she will not turn over. Spark plugs look good as does the manual fuel pump. Can you offer a few other suggestions?
just back from Iraq and Lost
SPONSORED LINKS
Saturday, November 1st, 2008 AT 4:51 AM
4 Replies
REDJEEEP
MEMBER
29 POSTS
What is the voltage at the batt?
Does the eng turn over when you turn the key
or you get nothing at all
get back to me will go from here
Was this
answer
helpful?
Yes
No
Saturday, November 1st, 2008 AT 10:40 AM
FINELINE1975
MEMBER
2 POSTS
It is trying to crank, but just isn't catching the spark. I am looking at getting a little cold crank spray to help it get that extra boost.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Saturday, November 1st, 2008 AT 11:13 AM
REDJEEEP
MEMBER
29 POSTS
That jeep should have a carb on it spray some starter fluid in in about 4 seconds worth than give it a try